diff --git a/doc/src/pair_adp.rst b/doc/src/pair_adp.rst index 6c4796fb85..bbfd98f677 100644 --- a/doc/src/pair_adp.rst +++ b/doc/src/pair_adp.rst @@ -56,8 +56,10 @@ command to specify them. * The NIST WWW site at http://www.ctcms.nist.gov/potentials. Note that ADP potentials obtained from NIST must be converted into the extended DYNAMO *setfl* format discussed below. -* The OpenKIM Project at https://openkim.org/browse/models/by-type provides - ADP potentials that can be used directly in LAMMPS with the :doc:`kim_commands interface `. +* The OpenKIM Project at + `https://openkim.org/browse/models/by-type `_ + provides ADP potentials that can be used directly in LAMMPS with the + :doc:`kim_commands ` interface. ---------- diff --git a/doc/src/pair_eam.rst b/doc/src/pair_eam.rst index 4710f8a9a1..7384a4d54c 100644 --- a/doc/src/pair_eam.rst +++ b/doc/src/pair_eam.rst @@ -149,6 +149,7 @@ potentials stored in DYNAMO or other formats: http://www.ctcms.nist.gov/potentials http://cst-www.nrl.navy.mil/ccm6/ap http://enpub.fulton.asu.edu/cms/potentials/main/main.htm + https://openkim.org These potentials should be usable with LAMMPS, though the alternate formats would need to be converted to the DYNAMO format used by LAMMPS @@ -156,6 +157,11 @@ and described on this page. The NIST site is maintained by Chandler Becker (cbecker at nist.gov) who is good resource for info on interatomic potentials and file formats. +The OpenKIM Project at +`https://openkim.org/browse/models/by-type `_ +provides EAM potentials that can be used directly in LAMMPS with the +:doc:`kim_commands ` interface. + ---------- For style *eam*\ , potential values are read from a file that is in the