Using
decomposePar -copyZero
The mesh is decomposed as usual but the '0' directory is recursively copied to
the 'processor.*' directories rather than decomposing the fields. This is a
convenient option to handle cases where the initial field files are generic and
can be used for serial or parallel running. See for example the
incompressible/simpleFoam/motorBike tutorial case.
- this makes it possible to perform additional operations
on surface values that have been previously sampled.
- support vectorField for weighting operations.
- reduce overhead by avoiding creation of weight fields, Sf fields
and combined surface geometries unless they are actually required.
- extend some similar concepts and operations to volFieldValue
Both stardard SIMPLE and the SIMPLEC (using the 'consistent' option in
fvSolution) are now supported for both subsonic and transonic flow of all
fluid types.
rhoPimpleFoam now instantiates the lower-level fluidThermo which instantiates
either a psiThermo or rhoThermo according to the 'type' specification in
thermophysicalProperties, see also commit a1c8cde310
Both stardard SIMPLE and the SIMPLEC (using the 'consistent' option in
fvSolution) are now supported for both subsonic and transonic flow of all
fluid types.
- handle sourcing bashrc with a relative path (issue #383)
- handle sourcing from bash and zsh.
Still need manual intervention when sourcing dash, sh, or ksh.
- replace grep in etc/cshrc with sed only
- logical instead of physical path for WM_PROJECT_DIR (issue #431).
Doesn't seem to be possible for csh/tcsh.
* Continue using physical locations when comparing directories,
but not for the top-level FOAM_INST_DIR, WM_PROJECT_DIR.
- relocate WM_CC, WM_CXX overrides from etc/config.*/compiler
to etc/config.*/settings to ensure that they are left untouched
when etc/config.sh/compiler is sourced while making third-party
packages (eg, gcc, llvm, CGAL).
- provide fallback FOAM_TUTORIALS setting in RunFunctions
STYLE: remove "~OpenFOAM" fallback as being too rare, non-obvious
Both point- and surfaceNoise utilities can operate on multiple input
files. However, if the files had the same name, the output would be
overwritten. To avoid this, the output files are now written to a
sub-directory including the path '/input<input-file-index>/', e.g.
postProcessing/noise/surfaceNoise/input0/nearWall/[fft|oneThirdOctave]
An optional 'outputPrefix' can be included (defaults to empty), e.g.
when set to 'test1':
postProcessing/noise/test1/surfaceNoise/input0/nearWall/[fft|oneThirdOctave]
